Notes for use of KTVled display in night bar

Time:2019-01-05 Views:28

Bar KTV night owners bar, lounge, service bar basic features and service functions, bar led screen for users with a high value, how to make the bar led electronic screen long-term value, how to maintain the bar screen better?In order to make the display life of bar DJ station longer, attention should be paid not only to the method, but also to the maintenance of the display.With the wide use of led display screen in bars, there are increasing problems in use, which are caused by various objective and subjective factors.Below introduces some matters needing attention and the maintenance method.Just like the traditional electronic products, in order to make the led display of night scene bar last longer, attention should be paid not only to the method, but also to the maintenance of the display.With the wide use of led display screen in nightlife bar, there are increasing problems in use, which are caused by various objective and subjective factors.Below introduces some bar ktvled display use notes and maintenance methods.

I. routine maintenance and maintenance of the main control computer

The computer is generally placed in the control room. In order to ensure the stability of the program played on the ktvled screen of the bar and good display effect, we should often carry out the following maintenance on the main control computer:

(1) keep the indoor environment of the control room clean, and regularly dust the computer and peripheral equipment, because the dust will pollute the computer keyboard, disk, display and main board and other important parts, may cause major failure.

When the computer is working, it will give off a lot of heat.If the heat is not good, indoor temperature is too high, easy to lead to the computer crash and other faults, long-term use will reduce the life of the main control computer, therefore, should pay attention to indoor ventilation.

If the environment temperature is higher, such as the hot summer months), the control room shall be installed fan, conditional can be equipped with air conditioning, temperature should be kept at 10 ℃ ~ 35 ℃ °, from 30% to 80% relative humidity, avoid computer work under high temperature and high humidity environment.

4. Check the hardware and peripheral equipment of the computer regularly, such as whether the graphics card and transmission card are loose, whether the DVI cable and RS232 serial cable are loose or damaged, etc. If any problem is found, it should be removed in time;

5 regular anti-virus treatment of the computer, especially to the Internet should be installed anti-virus software, should be timed to upgrade the playback software, ensure the latest version of the playback software.

Ii. Notes for change of led display control part of bar

The power cord of computer and control part can‘t be connected back, it should be plugged in the original position strictly.If there are peripherals, after the connection is completed, the chassis should be tested for electrification.

2. When moving the computer and other control equipment, check the connection line and control board for looseness before power on.

3. The position and length of the communication line and flat connection line of the bar ktvled display screen cannot be changed at will.