Notes for use of LED screen switch

Time:2018-11-29 Views:133

The correct switch of LED screen can get a better experience, so that LED screen can be used for a longer time.Therefore, it is necessary to understand the common switch precautions in the use of the screen.Otherwise, it will bring inconvenience to use.

Notes for switching led electronic display:

1 switch sequence:

Open screen: first turn on, then open screen.

Turn off the screen: first turn off the screen, then shut down

(turn off the computer and turn off the LED screen first, which will cause high highlights in the screen body and burn down the lamp tube, causing serious consequences.)

2, switch screen time interval should be more than 5 minutes.

3. After the computer enters the engineering control software, the screen can be turned on and powered on.

4. Avoid opening the screen in the state of full white screen, because the impact current of the system is the maximum at this time.

5. Avoid opening the screen when it is out of control, because the impulse current of the system is the maximum at this time.

6. The computer does not enter the control software and other programs;

B. The computer is not energized;

C the power supply of the control part is not turned on.

6.When the environment temperature is too high or the cooling condition is not good, you should pay attention not to open the screen for a long time.

7.Electronic display part of the body appears a line of very bright, should pay attention to timely close the screen, in this state is not suitable for a long time to open the screen.

8.If the power switch on the display screen often trips, please check the screen body or replace the power switch in time.

9.Check the fastness of the joint regularly.In case of loosening, pay attention to timely adjustment, re-strengthening or updating the lifting parts.

10.According to the environment conditions of LED screen body and control part, avoid insect bites, and place rodent repellent when necessary.